Micron Eagle  

Your Fluid Power Provider
Because we Care

TESTING

Whether it’s an open or closed loop pump, motor, or valve, our state of the art test facilities certify that all hydraulic components that leave our facility are set to original manufacturers’ published specifications, and in a simulated working condition for the setting of automotive, constant horsepower, and electro-hydraulic control systems.  This gives our customers the assurance that their unit, when installed, will perform the way it is supposed to.

This custom built 450 horsepower test facility is capable of varying test speeds up to 1,800 RPM, along with analyzing multiple ports simultaneously at loads up to 6,000 PSI.

This test facility gives us the ability to verify where applicaple the following for your pump, motor, or valve:

 
  • Case Drain Flow
  • Case Drain Pressure
  • Case Drain Tempurature
  • Flow at Ports
  • Holding Amps
  • Holding Watts
  • Inlet Vaccum Pressure
  • Inrush Amps
  • Leak Free
  • Max Continous Current
  • Max Flow Ratings
  • Max Load Impendence


 
  • Max Pressure Level
  • Max Pressure Ratings
  • Max RPM Level
  • Max Switching Frequency
  • Max Venting Pressure
  • Max Volume Control
  • Min Controllable Flows
  • Min Flow Ratings
  • Min Pressure Ratings
  • Min Venting Pressure
  • Pressure Changes
  • Pressure Drops

 
  • Pressure Versus Current
  • Pressure Versus Flow
  • Pressures at Ports
  • Resistance
  • Response Times
  • RPM Versus Flow
  • RPM's
  • Solenoid Coil Rating
  • Spool Arrangement
  • Temp at Ports
  • Vent Pressure Versus Flow
Why Test
Testing your rebuilt hydraulic components just makes sense. Why risk thousands of dollars on a repair, just to find out that the unit is off specification which can lead to more downtime, or even worse, a catastrophic failure.

Knowing your rebuilt unit is performing to original specifications ensures that your system will operate efficiently, and with minimum wear and tear.
  • Testing confirms that pressure settings are within the acceptable designed range aids in keeping wear and tear to a minimum.
  • The case drain flow and pressure are a key reading. Testing will confirm that these two parameters are within an acceptable level .
  • Testing ensures speed settings are within specified limits, preventing any potential permanent damage to the system.
  • Testing confirms internal toleances and displacement stops that define performance specifications.